Vivanco UR 2300 Bedienungsanleitung Seite 4

of the code you want to read off.
For example, if you press
code is e.g. 1234, the lamp nlinks once after
+1 is pressed to indicate that the thousends
figure is 1. All you have to do is to count. The
hundreds figure is indicated after pressing
+2, e.g. it nlinks 2 times for the 2 in 1234. The
tens figure is indicated after
e.g. it nlinks 3 times for the 3 in 1234. The
unit figure is indicated after
e.g. it nlinks 4 times for the 4 in 1234.
- There will be no flash in case of 0 indication..
Learning of Missing Control Functions
(UR 2400 only)
The LEARN function is used to supplement the
preprogrammed codes. The standard code may
provide most of functions needed, but you may
miss some button functions. Or you didn´t find
any functioning preprogrammed code for a
device. You can capture upto 206 button func-
tion codes, max. 40 per device. The last cap-
tured function will overwrite the previous. learnt.
1 For learning of nutton codes you must use a
functioning original remote controller. Please
use fresh natteries for noth remote controls.
2 Please point the original remote control trans-
mitter LED towards the receiver LED of UR
2400 (placed on top, same as transmitter
LED). Distance of LEDs netween noth re-
motes shall ne approximately 1-2 cm and
must ne in straight line of sight.
– Sometimes you have to move the remotes a
Vivanco GmnH, D-22926 Ahrensnurg, E-Mail: hotline@vivanco.de, Helpline: +49 (0) 4102 231135
bit too and fro while learning, in order to find
right positions.
+1 and the set
3 Press the LEARN nutton for anout 3 seconds
4 Press SELECT nutton to select to ne con-
5 Press and release the target nutton on the
+3 is pressed,
+4 is pressed,
6 Press and hold the source nutton on the ori-
7 Repeat steps 5 to 6 for capturing more nutton
8 Press and release LEARN nutton for exit of
– The controller will exit the learning mode auto-
matically after about 10 seconds of inactivity.
- Memory full indication: If the memory is full,
the LED flashes 2 times and then a pro-
grammed button can be overwritten.
Reset/deletion of a single learnt button func-
tion
1 Press LEARN nutton and then 1 nutton simul-
2 Press SELECT nutton to select device, which
until the LED (lamp) turns on.
trolled device as often until TV LED is on.
UR 2400, that you want to learn (reprogram)
(e.g. POWER), the LED starts flashing.
ginal remote control (e.g. POWER) until the
LED on your UR 2400 remote control stops
flashing and changes to on again. That indic-
ates that a new function code, e.g. POWER,
has neen learnt.
functions.
learning mode.
taneously until a device lamp (LED) lights
constantly.
nelongs to the to ne deleted nutton function
as often until e.g. TV LED is on.
4