Intended Use; Technical Description; Installing The Seat Heater - Waeco MagicComfort MSH100 Bedienungsanleitung

_MSH100.book Seite 20 Montag, 6. September 2010 6:37 18

Intended use

4 Intended use
The MagicComfort MSH100 (item no. 9101700010) seat heater is suitable
for fitting in the front vehicle seats.
NOTICE!
A
For vehicles equipped with side airbags in the seat backrests, seat
occupancy detection or child seat detection, observe the vehicle
manufacturer's specifications.
5

Technical description

The heating elements for the MagicComfort MSH100 seat heater can be
installed in the driver's seat and the passenger seat.
The shape of the seat is not altered by the heating elements.
The seat heater is operated using a switch.
6

Installing the seat heater

6.1 Tools required (fig. 1, page 2)
For installation and assembly you will need the following tools:
Drill bit set (1)
Drill (2)
Screwdriver (3)
Set of ring or open-ended spanners (4)
Measuring ruler (5)
Hammer (6)
Centre punch (7)
To make and test the electrical connection, the following tools are required:
Diode test lamp (8) or voltmeter (9)
Crimping tool (10)
Insulating tape (11)
Hot air blower (13)
Soldering iron (14)
Solder (15)
Cable bushing sleeves (if necessary)
20
MagicComfort MSH100