Before Initial Use; Assembly Of The Cordless Sweeper; Charging The Battery - Silvercrest SABD 3.6 Li B1 Bedienungsanleitung

ATTENTION! PROPERTY DAMAGE!
Charge the appliance only with the supplied mains adapter/charger
►
(type SABD 3.6 Li A1-1)!
Only this cordless sweeper may be charged with the supplied battery
►
charger; the charger is not suitable for other batteries.
Never try to recharge non-rechargeable batteries.
►
GB

Before initial use

■ Remove all packaging materials from the ap-
pliance. Including the plastic safety catch that
secures the switch
during transportation.

Assembly of the cordless sweeper

■ Attach the handle
–
If necessary, turn the screw catch
a little so that you can insert them into the
handle elements.
Push the 3 handle elements
and turn them so that the screw catches
open up and the handle elements are firmly
connected.
–
Push the grip
catch
–
Push the assembled handle
screw catch
appliance.
■ Push the dirt container
ance.
20
from accidental activation
:
together
onto the shaft and turn the
so that the grip is firmly seated.
with the
into the holder
back onto the appli-
–
The two guide pins on the side of dirt
container
rails on the appliance.
–
Push the dirt container
until the release knob

Charging the battery

To ensure that the battery reaches its full perfor-
mance potential, it is necessary to charge the bat-
a down
tery for around 5 hours before the first use. Further
charges will take up to 5 hours depending on the
discharge level of the battery.
With a fully charged battery, the appliance provides
an operating time of 50 minutes before recharging
will be again required.
ATTENTION! MATERIAL DAMAGE!
► Use only the supplied charger.
► Operate the appliance only with the built-in
on the
battery.
► Never attempt to remove the battery to
recharge it.
► Do not attempt to open the battery housing
or dismantle the battery. This will destroy it.
1) To charge the battery, ensure that the cordless
sweeper is switched off.
Switch it off using the switch
NOTE
Do not use the cordless sweeper when it is con-
nected to the charger.
must grip into the angled guide
onto the appliance
clicks into place.
if required.
SABD 3.6 Li B1