General Information - Skylotec Hoist Fix Gebrauchsanleitung

(SELF BELAYING)
Follow guidelines on figure 5.
Because of a danger of a fall a 10 mm or thicker rope must be used.
Figure 6: MIXED PROGRESSION
Avoid exceeding the height of the attachment to the rope with the
point of attachment to your harness (always keep the fall factor <1).
Because of a danger of a fall a 10 mm or thicker rope must be used.
Figure 7: HORIZONTAL PROGRESSION
As shown on figure 7.
Figure 8: HAULING SYSTEM
In any hauling system composition shown in figure 8 an ascender
(H-064-L, H-064-R) may be replaced by a bloquer (H-058, H-063).

GENERAL INFORMATION

Packing, storage, maintenance and cleaning
Each product is packed with its INSTRUCTIONS FOR USE in a card-
box. Proper maintenance and storage are imperative to ensure cor-
rect functioning of the product (as well as all your equipment) and
thus your safety.
Clean the product with a brush under running cold water of domestic
supply. If the stains persist, clean it in warm water (maximum 30°C)
with ordinary soap. Then rinse thoroughly, wipe it with a towel and
dry naturally in a shaded ventilated place away from sources of heat.
If needed, lube sparingly the moving joints of the cam with silicon
based oil.
Temperatures
While it is allowed to use this product within the temperature range
from -40 °C to 60 °C, it is advisable to stock it in a dry place at room
temperature.
Lifetime
It is impossible to indicate the exact lifetime of this product for it de-
pends on frequency and mode of application, on environment where
it is used (marine, cave, corrosive atmosphere), and on mechanical
wear or damage. Provided its correct use (in concordance with these
instructions), the lifetime of the product at average use in expected
to be 7 years.
Guarantee and its limitations
21 21