Carpetlight CL21 Bedienungsanleitung Seite 26

the DMX chain, the use of a 120 Ω (Ohm) termination/load resistor could be necessary
(not included with the lamp).
4. display Backlight
Display Brightness:
- Press the standby/menu button for 3 seconds (menu-mode).
- Press the standby/menu button briefly select the menu function "Backlight".
- Use the color temperature control to choose the required setting 0-5.
- By pressing the standby/menu button again for 3 seconds the input is selected
and the lamp reverts to the lamp operation mode.
5. selection of lamp Head version
The detection of the lamp head version is done automatically. This procedure guarantees
an accurate match in the color temperature display. Alternatively the lamp version can
be selected manually. you can find the lamp version on the printed logo on the lamp
heads rear side. Higher lamp versions have a large color spectrum adjustability. The
following lamp versions Cl42, Cl44 and Cl84 come in A series (with the conventional
binning) and B series ( with the new one extended binning). The Cl21 lamp with the
A-C series is operated with the conventional binning and the lamps with the D series
operated with the new extended binning. When connecting the lamp the maximum color
temperature is measured to see the correct color temperature in the display.
It is also possible to manually adjust this in the menu.
- Press the standby/menu button for 3 seconds (menu-mode).
- Press the standby/menu button briefly to select the menu function "Connected
Lamp Series".
- Use the color temperature control to choose the required lamp series from A or B
respectively A-C or D (for Cl21).
- By pressing the standby/menu button again for 3 seconds the input is selected
and the lamp reverts to the lamp operation mode.
the following menu points are not adjustable :
6. Software version of the control unit.
7. Serial number of the LED panel
8. Temperature display of the thermo-sensors & voltage
26