Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
lAmP oPeRAtion
Ancillary Assembly
The assembly and changing of the ancillary equipment is to be carried out from a stable
position.
erecting the frame Cl21 and Cl42
Fold the four arms away from the centre mount and lock in final position.
The four velcro stripes and the center velcro are to be found on the front side of the
frame crossing.
The frame for the Cl42 uses four additional ¼" bolts with wing nuts.
Assembly of the lamp Cl21 and Cl42
We recommend using the supplied threaded pins when using the lamp frame. The velcro
fasteners on the rear of the lamp should be attached to the velcro on the frame arms,
covered over and pressed together.
Always begin the attachment of the lamp to the frame at the cable emergent corner. The
lamp includes at each of its four corners an eyelet to attach the lamp or fasten it to the
frame. Push the threaded pins through the oval eyelets of the Cl21 lamp and screw tightly
into the ¼" set screw of the frame.
When erecting the Cl42:
Once, all threaded pins are slightly screwed in, the ¼" receptacle tubes can be pushed to
their outermost position and secured by their wing nuts, then tighten the threaded pins.
This procedure ensures the maximum tension on the frame /lamp system. We recommend
whilst tensioning loosening the velcro fasteners at the corners.
When assembling the softboxes make sure the connectors (quick straps, velcro) are attached
to the the lamp before the ¼"receptacle tubes are pushed to their outermost position, also
tighten the threaded bolts/wing nuts after that.
Assembly of the Corner fixtures lamp Cl44 and Cl84:
The four corner fixtures are for empty 4x4 aluminium frames, the sizing is 1,2 m x 1,2 m.
The best frames for assembly with the Cl44 and Cl 84 are ones without corner welds.
The corner fixtures must be correctly attached to the frame corners. To do this, the
hold down clamps need to be moved aside. We recommend undoing the wings nuts up
to their highest position on the thread. Once the corners of the frame are in position,
the hold down clamps can be adjusted using the wing nuts.
Assembly of the lamp onto the frame Cl44 and Cl84
The lamp uses four corner fixtures for attaching to an empty aluminium frame.
Attached to the corner fixtures are four thrust latches which firstly need to be loosened
and moved aside.
The lamp is then attached using the eyelets, which are screwed directly onto the thrust
latches, and there the affixing pins for the lamp and a softbox are assembled.
Alternately one can easily use the wing nuts attached to the thrust latches for affixing
21
Werbung
Inhaltsverzeichnis
