Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
oPeRAtion of tHe ContRol unit
Power Switch
Display
Button
CL 20/40 CONTROLLER
STANDBY
MENU
DC IN
LAMP
Brightness
Color Temperature
5/6 Lamp-Socket
DC IN
Control
Control
Speakon
The control unit must be connected to the lamp body using the supplied 6 pole control
cable or respectively a 5 pole control cable. Do not twist or turn the connectors! The
plugs and sockets for the 5 pole control cable are push /pull types to be disengaged
by pulling back the centre shell of the plug. The principle of the 6 pole control cable is
STANDBY
the same as with the 5 pole cable only that it has an extra interlock that hinders uncon-
MENU
trolled unplugging. When inserting the plug into the socket make sure the arrow mark on
the plug is pointing upwards. Take note of the white marker.
The speakon-DC connector is a lockable slewing mechanism. Plug the connector into
the socket by finding the correct slot and then with a little pressure turn to the right.
To disconnect, retract the silver slider, then slightly rotate left, then you can unplug the
cable.
there are different types of power supply
mains supply 90-240 Volt
Connect the speakon DC plug of the power supply to the speakon socket (DC IN) by
inserting and twisting right. (To unplug pull the top lever back and twist left).
After that, connect the power supply to the mains outlet with the supplied AC cable.
V-mount operation
Connect the Speakon DC plug of the supplied V-mount adapter to the speakon socket
(DC IN) by inserting and twisting right. (To unplug pull the top lever back and twist left.)
After that insert two batteries (with a minimal discharge current of nine Amps/each) to
the V-mount adapter.
An alternative DC power supply can be used after approval by CARPetligHt GmbH.
Do not connect or disconnect the connectors of the power and control cable while
voltage or current are present.
We decline any liability for damages caused as a result of non observance.
23
Werbung
Inhaltsverzeichnis
