Important Safety Instructions - Carpetlight CL21 Bedienungsanleitung

imPoRtAnt sAfety instRuCtions

Beware: mains Voltage!
Acute danger to life!
• Attention: The lamp body can reach high temperatures!
• When in use the lamp body should neither be rolled nor covered up, nor should
it be pressed or tied down to any surface, as the heat generated during operation
needs to dissipate from the whole surface of both rear and front side.
We generally recommend the use of the supplied frame.
• Don´t stick any nails, pins, staples or similar objects into the lamp body, please
use the existing eyelets.
• Do not operate the lamp if you observe any visual damage.
• If any damage is identifiable the relevant parts must be replaced, alternatively, please
contact CARPetligHt GmbH or one of our distributors/sales partners.
• Please ensure, when hanging this product, that the lamp body and ancillary equipment
is properly secured using a safety cable.
• Due to the lamp body being one of the lightest of its kind, it allows for installation
in ways not possible before; but please make sure of the stability and reliability of
the attachment.
• Stands must be set up correctly and it is to be ensured that they are designed to
carry the designated load.
• The lamp is equipped with four thermosensors located at the corners to protect
the lamp from overheating and other possible damages. The temperature warning
mode is activated once 176°F (80°C) is reached at any one of the four thermosensors.
• Please take notice of the warning sign on the control unit. Turning down the
dimmer a few percent should reduce the heat noticeably.
• When the lamp becomes overheated it automatically reduces its output to 20%, until
a harmless temperature is reached.
• It is advisable to wear suitable protective clothing when working with lamps to
prevent injuries and burns.
• Please observe the weight of lamp bodies and ancillary equipment when carrying or
lifting, and take into consideration preventive measures recommended by local trade
Associations according to occupational safety law.
• When laying out the connecting cables please avoid tripping dangers for personnel or
damages that can occur from vehicles by using suitable warning signs and/or coverings.
• The lamp body and its electrical safety system are to be inspected prior to any operation.
Beware: Hot lamp!
19