Mounting The Spigot; Assembly Of The Snapgrid; Assembly Of The Softboxes; Assembly Of The Skirt - Carpetlight CL21 Bedienungsanleitung

to the eyelets. Subsequently all four thrust latches should be pushed outwards and
adjusted using the wing nuts to bring tension to the lamp.

mounting the spigot

The lamps CL21 and CL42 have a centre mounted bayonet fastener for attaching a 16mm
spigot. The spigot is placed within the fastener, turned slightly then tightened using the
union nut. Previous versions have a spigot that is attached using a thread.

Assembly of the snapgrid

The original CARPetligHt SnapGrid has been especially developed for the respective
lamp sizes.
It can be attached using the velcro fasteners which surrounds the lamp body, or alter-
nately directly to the softbox.
Additional rubber straps can be tightened over the four corners using the threaded pins.
The velcro fasteners provide enough support to use the lamp as a top light.
Use the protruding textile hem corner extensions on the SnapGrid to minimise any
unwanted light emissions from the corners of the lamp.
Please check for possible fouling of the velcro fasteners to ensure a perfect bond.

Assembly of the softboxes

Both of the CARPetligHt softboxes can be connected using the quick straps (push/
pull operation) over the threaded pins, and using the velcro fasteners at the corners of
the lamp body.
It is possible to combine the softbox and SnapGrid.

Assembly of the skirt

When using the lamp as a top light, it is recommended for some applications to use the
black skirt, to narrow down the light angle even further.
The skirt can be used separately or in combination with the softbox and/or the SnapGrid.
Simply attach the velcro affixed to the skirt to the velcro attached to the lamp body or
its ancillary equipment.
22