Rear Panel Overview; Rear Panel Description - AUDAC CMP30 Bedienungs- Und Installationsanleitung

Rear Panel overview

Rear panel description

Power inlet:
The mains power supply (110~240V AC / 50~60 Hz) has to be applied to this AC power
inlet. The connection is made by an IEC C14 power connector which is fitted with a fuse.
When replacing the fuse, make sure that the value of the replacement fuse matches the
value of the original fuse. (T500mAL/250V)
RS232 control port:
The RS232 control port can be used for controlling the device through external hardware
such as audiovisual installations, home & industrial automation systems, computers, ...
The complete commands list for controlling the CMP30 through RS232 can be
downloaded from the AUDAC website.
Variable audio output CD/MP3/Tuner:
The variable audio output can be switched between CD/MP3 or tuner mode and the
output level (volume) can be adjusted. The selection and volume adjustment should
be done using the rotary function dial. In most basic audio application where only one
simultaneous source is required (either CD/MP3 or tuner), the variable audio output will be
used.
Fixed audio output CD/MP3:
The signal on this output is dedicated to the CD/MP3 player, and has a constant line
output level (the volume is not adjustable). This output can be used for audio applications
where multiple sources are simultaneously used (CD/MP3 and tuner), such as Multi-Zone
audio applications.
Fixed Audio Output Tuner:
The signal on this output is dedicated to the tuner, and has a constant line output level
(the volume is not adjustable). This output can be used for audio applications where
multiple sources are simultaneously used (CD/MP3 and tuner), such as Multi-Zone audio
applications.
FM Antenna connection:
Connect the supplied FM antenna to those connectors to ensure a good FM reception. In
case of bad reception, the connection of an external outdoor antenna or cable distribution
can significantly improve the audio reception.
13