TFA 60.5013 Bedienungsanleitung Seite 9

TFA_No. 60.5013_Anleit_10_17
Radio-controlled projection clock with thermometer
• Batteries contain harmful acids. Low batteries should be changed as soon as
possible to prevent damage caused by leaking. Never use a combination of
old and new batteries together, nor batteries of different types.
• Wear chemical-resistant protective gloves and safety glasses when handling
leaking batteries.
Important information on product safety!
• Do not place your device near extreme temperatures, vibrations or shocks.
5. Elements
A: LCD-Display:
A 1: 1. Time with seconds
A 2: Snooze symbol
A 3: Daylight Saving Time symbol
A 4: Radio-controlled time symbol
A 5: Time zone symbol
A 6: Date with weekday or week number
A 7: Indoor temperature, alarm 1, alarm 2, dual time
B: Buttons:
B 1: Dial for focus
B 2: SNOOZE/LIGHT sensor button
B 3: ALARM button
B 4: TEMP/FLIP button
B 5: MODE button
B 6: UP button
B 7: DOWN button
B 8: °C / °F / WAVE button
B 9: CONTINUE PROJECTION switch
16
17.10.2017 9:58 Uhr Seite 9
Radio-controlled projection clock with thermometer
C: Housing:
C 1: Battery compartment
C 2: Power socket
C 3: USB port
6. Getting started
6.1 Inserting the batteries
• The batteries will operate as a backup power source in case of power failure.
• For a permanent projection, to use the charging function and to conserve bat-
tery power, use the supplied power adapter.
• Open the battery compartment and insert two new batteries 1,5 V AA, polarity
as illustrated.
• Close the battery compartment again.
• Insert the adapter into the jack at the device and connect the power adapter to
a wall socket.
• Important! Make sure that your household voltage is 240V! Otherwise your
device may be damaged.
• The device is ready for use. All LCD segments will light up for about 2 se-
conds.
• The clock will scan the DCF frequency signal and the DCF symbol flashes on
the LCD. When the signal is received successfully after 3-5 minutes, the radio
controlled time and the DCF symbol appears permanently.
• In Daylight Saving Time "S" is shown on the LCD.
• If the reception fails, activate the reception manually by holding °C / °F /
WAVE button for 2 seconds.
• In case the clock cannot detect the DCF-signal (for example due to distur-
bances, transmitting distance, etc.), the time can be set manually. The clock
will then work as a normal quartz clock. (see Manual setting of clock and cal-
endar).
Note for radio-controlled time DCF
The time base for the radio-controlled time is a caesium atomic clock operated by
the Physikalisch Technische Bundesanstalt Braunschweig. It has a time deviation
17