Wi-Fi Access Point - netio 4 Schnellinstallationsanleitung

Wi-Fi Access Point

NETIO 4 and NETIO 4All support Wi-Fi 802.11 b/g/n 2.4 GHz (AP mode and
Client mode).
Wi-Fi defaults
Network SSID:
Security:
Encryption:
Password:
Default IP:
NETIO 4 / NETIO 4All is initially configured as a Wi-Fi Access Point so that any
PC or other device with a Wi-Fi adapter can connect to it.
The LAN adapter of NETIO 4 and NETIO 4All is active, too.
Support
If you encounter any problems with your device, please consult your supplier. Before
you do so, please verify that your product uses the latest firmware version. Also, try
restoring factory default settings.
Note:
The manufacturer assumes no responsibility for any technical or printing errors and
reserves the right to modify the product or this manual without prior notice. Such
changes are announced at the manufacturer's website
http://netio-products.com.
The manufacturer disclaims all warranties of any kind with respect to the contents of
this manual, as well as all implied warranties of merchantability or fitness for a
particular purpose.
In particular, the manufacturer disclaims all responsibility for any damages caused by
incorrect use of the product, failure to comply with instructions and recommendations
in the user manual and/or unprofessional actions of third parties not authorized by
the manufacturer to perform warranty service.
Netio4
WPA2-PSK
AES
12345678-Netio4
192.168.2.78
© 2017 NETIO products a.s. All rights reserved.
9
January 2017