netio 4 Schnellinstallationsanleitung Seite 6

LED indicators, buttons and sound signals
LED indicators [1] to [4]
Device power-up
Standard mode
Maintenance mode
Reset to factory defaults in progress
Firmware upgrade in progress
"Locate" function
DHCP failure
LED indicators for Wi-Fi / Bluetooth
Active (connected)
Inactive
Buttons
Control of outputs [1] to [4]
Enter maintenance mode
Restore factory defaults
Sound signals
Device power-up
Restart in maintenance mode
Restoring factory defaults
Restoring factory defaults complete
[1, 2, 3, 4] light up red during device
power-up
[1] to [4] off when the output is off
[1] to [4] lit green when the output is on
[1] to [4] flash green for delayed switch-
on
[4] lights up red
[1] to [4] flash red
[3] flashes red, [4] lights up red
[1] flashes red
[2] lights up red
On
Off
To switch the output on or off, press and
hold the button for 2 seconds
When powering up the device, press
and hold [4] until the device beeps twice
(10s at the most)
When powering up the device, press
and hold [1] and [2] until the device
beeps twice (it can take up to 20s)
One beep
Two beeps
Three beeps
Two beeps
6