Collomix CMG 1700 Originalbetriebsanleitung Seite 14

Assembly

Disconnect the mains plug from the wall
plug before carrying out any tasks on the device.
Adjusting the handle
Open the two wing nuts left and right and move
the handle to the desired position. Tighten the
wing nuts again.
Mounting the diamond grinding disk:
Select a diamond grinding disk that matches the
grade and specification of the material to be pro-
cessed.
Only use diamond grinding disks that comply with
the data listed in the table below.
Ensure the correct size, height and diameter of the
hole in the diamond cup wheel.
The permissible rotational speed of the diamond
grinding disk used must at least match with the
data listed in the following table.
Please note the data provided on the diamond
grinding disk regarding its rotational and circum-
ferential speed.
max D [mm] Max. rotational
[mm] d speed [min
125 22.2
► Unscrew the coupling nut (8) from the thread-
ed spindle using the socket spanner provided.
While doing this, press the locking button (2)
and turn the spindle by hand until you can feel
it engage.
► A flange nut (6) is attached to the threaded
spindle to stabilise the cup wheel. When work-
ing with the suitable Collomix diamond cup
wheel, always ensure that the flange nut is in
place. Do not operate the device without the
flange nut.
► Centre the diamond cup disk (11) on the flange
nut and spacer disk.
► Use a pinhole spanner to tighten the clamp
nut (10) on the threaded spindle. Press and
hold the arrester button (3) while doing so to
prevent the spindle from turning.
► Check the cup disk for correct seating and free
running before switching on the machine. The
disk must not come into contact with the pro-
tective hood or other parts.
The cup wheel can heat up during use. Leave to
cool. You could burn your hands or cut/ tear your
skin on the segments. Always wear protective
work gloves when changing tool inserts.
max.
] [m/s]
-1
12250 80
Carry out a test run in a safe position and without
any material load. Interrupt your work immediate-
ly if you notice the tool running irregularly.
Only use original accessory parts!
Mounting the cup wheel
height
[mm]
22
Rev. 3 / 14
6
7
8