Inhaltsverzeichnis
Werbung
PUMP
Make sure that the pump is clean and in good condition to increase equipment working life.
If the pump is an intensive™ one :
- Regularly clean the wetting-cup with "T" lubricant (this "T" lubricant will normally be coloured by the
paint).
- Regularly clean the wetting-cup with solvent after having drained the lubricant (unscrew the plug on
the upper flange).
Guards (air motor cover, coupling shields, housings,...) have been designed for
The manufacturer will not be held responsible for bodily injury or failure and / or
damage to property due to removal or partial or removal of the guards.
Make sure that the suction strainer is clean and in good condition. Regularly clean it and change it if
necessary.
Flush the pump as often as necessary, specially when spraying pigment-filled material.
Whatever the case, when stopping the pump, always leave it filled with material.
For a short duration shutdown, if the flushing has not been carried out, leave the pump
filled with material.
For a short duration shutdown, after flushing the pump, leave it filled with solvent.
SPRAY GUN
Comply with the usual instructions of spray gun servicing (refer to spary gun instruction manual).
FILTER
If the pump is mounted with a filter at the fluid outlet, comply with the usual instructions of filter
servicing (refer to filter instruction manual)
KREMLIN REXSON
safe use of the equipment.
- 1 -
N° : 578.033.110-UK-1106
Werbung
Inhaltsverzeichnis
