Initital Use; Inserting / Changing Batteries; Inserting The Sd Card; Protective Films - Kaleas 43010 Bedienungsanleitung

Initital use

Check that the device and accessories are complete prior to initiation
(see "scope of delivery", page 31).

Inserting / changing batteries

• Push the lid of the battery compartment in the direction of the arrows
and remove the batteries.
• Insert the lithium ion accumulator provided (contacts together).
! Make sure that the polarity of the accumulator is correct in order to
prevent damage.
• Close the battery cover by pushing the lid back until it locks in place
and the lid is firmly positioned.
Remove the batteries / accumulators if the device is not going to be
!
used for a long time to prevent damage caused by leaking batteries /
accumulators.
 The battery status symbol
Top up the device with electricity using the charging cable if the accu-
mulator is empty, otherwise the camera will switch off if the accumula-
tor charge is low after 10 seconds.

Inserting the SD card

• Open the cover at the side and insert the SD card until it clicks into
place. Close the cover.
• To remove the SD card, press it down firmly. The card will pop out
slightly and can then be removed.
 The SD card must be formatted so that the CarDVR can access it.

Protective films

• Open the display and remove the protective film.
• Remove the protective film from the lens and the suction cup on the
bracket.
20
indicates the charge of the accumulator.
CarDVR ENGLISH
© KALEAS GmbH & Co. KG