You would like your calls from Line 1 to be redirected to Line 2 if
Line 1 is busy.
Usually with Phone, all calls are redirected to your upc cablecom box if the line
is busy. In this scenario, you have to program a «call divert when busy» from
Line 1 to Line 2.
Enter the following key combination in the Siemens ISDN telephone Siemens
(Line 1) as described in your Phone Operating Manual:
• Pick up the receiver and enter the key combination *67*
• Enter the number, to which you divert the call: 044 535 1116 (i.e. for Line 2)
and exit by pressing the hash key #.
• Wait for confirmation of service activation and put down the receiver
• The call divert only works when you observe this procedure!
You would like your fax to receive all incoming calls on Line 2. However, the
Philips ISDN telephone should not ring on Line 2. Nonetheless, you would like
to use the Philips telephone for making calls when Line 1 is busy.
You can activate this function via any of your ISDN telephones:
To block ringing on Line 2 (as described above), follow this procedure:
• Enter 000002021 on the ISDN telephone without lifting the receiver.
• Now pick up the receiver and replace it.
• The «CONF» lamp on the ISDN telephone adapter does not light up.
This is how you deactivate this service:
• Enter 000002020 on the ISDN telephone, without lifting the receiver.
• Now pick up the receiver and replace it.
• The «CONF» lamp on the ISDN telephone adapter now lights up.
You can program Line 1 in the same way with the activation code 000002011
and the deactivation code 000002010.
58