Connection Of The Expansion Tools; Removing/Changing Of The Expansion Tools; Connecting The Bending Tool - GF JRG Sanipex MT 4810.000 Bedienungs- Und Wartungsanleitung

3.4 Connection of the expansion tools

• Connect the hydraulic coupling (1) to the hydraulic nipple (24) of the corresponding
expansion tool
• Switch on hydraulic unit on the main switch (21)
Remark:
Impurification
Please make sure, that the hydraulic nipple and the hydraulic coupling are free
of any contamination.
The device is now ready for operation for expanding pipe ends.
(Installation procedure, refer to chapter 5.1.1)

3.5 Removing/Changing of the expansion tools

Remark:
Change of tools
During the expanding process the expanding unit should not be disconnected!
The expanding process is finish if the expanding mandrel is completely returned.
• Retract the coupling sleeve of the hydraulic coupling (1) and disconnect the hydraulic
hose (2) from the expansion tool
• Connect the hydraulic coupling (1) to the hydraulic nipple (24) of the required
expansion tool
The device is now ready for operation for expanding pipe ends.
(Installation procedure, refer to chapter 5.1.1)

3.6 Connecting the bending tool

• Setting-up the bending tool (refer to 5.2.1)
• Switch off hydraulic unit on the main switch (21)
• Connect the hydraulic coupling (1) to the hydraulic nipple (32) of the bending tool
Remark:
Impurification
Please make sure, that the hydraulic nipple and the hydraulic coupling are free of
any contamination.
72