Commissioning; Transportation Security Devices; Operating Conditions; Hydraulic Device - GF JRG Sanipex MT 4810.000 Bedienungs- Und Wartungsanleitung

3

Commissioning

3.1 Transportation security device
Danger:
Transportation security device
The hydraulic device could suffer
damage! Remove the black O-ring
(transportation security device) on
the plug of the red aeration – and
venting screw (6) and store it in the
installation tool box.
Remark:
Transportation security device
Install the transportation security device again (black O-ring) for a longer
transportation (e.g., a return to the manufacturers works) for the purpose of
preventing an oil loss.

3.2 Operating conditions

• Place the hydraulic unit onto flat
and even surface or suspend it
from the carrying strap (9) in a
horizontal position
(Pay attention to symbol 3)
• The JRG Sanipex MT tools are
water-splash protected
• The mains voltage must correspond
with the indication on the name plate
Warning:
Voltage peaks
Voltage peaks, which exceed the mains voltage indicated on the name plate, can
damage the device. When connecting it to electric power generators, especial attention
has to be paid to voltage peaks.
• Always connect to protective conductor. (The device has to be grounded!)

3.3 Hydraulic device

• Check the hydraulic oil level (refer to page 73)
• Connect the hydraulic device to the mains with the mains plug (5)
• Switch on the mains switch (21)
functioning of the light-emitting-diodes (LED) (13 to 18), these briefly light up.
In case of a correct connection to the electric mains, the device is ready for
operation, when the LEDs for mains voltage (13) and expansion mode (14) are lit
as a check for the electronics and for the
71