Operating- And Display Elements; 2.2/2.3 Light-Emitting-Diode Display (Led) - GF JRG Sanipex MT 4810.000 Bedienungs- Und Wartungsanleitung

2

Operating- and display elements

2.1 Start button on the hydraulic device
The start button on the hydraulic device is used for triggering the expansion process.
(Refer to chapter 5.1.1)
This start button must not be utilised for bending pipes!
2.2 Start Button on the bending tool
The start button on the bending tool is utilised for triggering the bending process.
(Refer to chapter 5.2.2)
2.3 Light-emitting-diode display (LED)
No. Designation
13 Mains voltage
14 Expansion mode When the device is ready for
15 Bending mode
16 Servicing
17 Frost
18 Over-
temperature
70
Lights-up ...
When the device is switched
on and mains voltage is
present.
expanding pipe ends.
When the device is ready for
bending pipes.
After 70'000 working cycles.
The complete JRG Sanipex
device in the interest of
operational safety has to be
returned to the sales point
at the next opportunity for
an overhaul.
At an oil temperature of
between –5°C up to –15°C
the device can be operated
normally. Recommendation:
Connect an expanding- or a
bending unit to the hydraulic
unit. Start the expanding
respectively the bending
process (without fixed pipe
inside). Repeat this pro-
cedure, until the LED will
extinguish.
At an oil temperature of
between +50°C up to +70°C
the device can be operated
normally.
Blinks ...
After an abortion of the
expansion process.
(Refer to chapter 6)
After an abortion of the
bending process through a
too long operating time.
(Refer to chapter 6)
After 75'000 work cycles,
the complete JRG Sanipex
MT toll in the interest of
operational safety must
not be utilised anymore
and immediately has to be
returned to the sales point
for an overhaul.
(Refer to chapter 6)
At an oil temperature of
below 15°C.
(Refer to chapter 6)
At an oil temperature of
above70°C.
(Refer to chapter 6)