Electrical Safety - Bosch ALR 900 Originalbetriebsanleitung

OBJ_BUCH-835-003.book Page 13 Wednesday, March 11, 2015 9:10 AM
tines/blades and fixed parts of the
machine.
 Regularly inspect the supply cable
and any extension cables. Do not
connect damaged cables to the
supply or touch a damaged cable
before it is disconnected from the
supply. A damaged cable can lead to
contact with live parts. Beware elec-
tric shock hazard.
 Do not touch the tines before the ma-
chine is disconnected from the sup-
ply and the tines have come to a com-
plete stop.
 Keep supply cables and extension
cables away from the tines. The
tines can cause damage to the cables
and lead to contact with live parts.
Beware electric shock hazard.
Remove the plug from the socket:
– Whenever you leave the machine.
– before clearing a blockage,
– before checking, cleaning or working
on the machine,
– after striking a foreign object. Inspect
the machine for damage and make re-
pairs as necessary,
– if the machine starts to vibrate abnor-
mally (check immediately).
Connecting to the mains

The voltage indicated on the rating
plate must correspond to the voltage
of the power source.

We recommend that this equipment
is only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA residu-
al current.
Bosch Power Tools
 Only use or replace power supply ca-
bles for this unit which correspond to
the types indicated by the manufac-
turer. See the operating instructions
for the order no. and types.
 Never touch the mains plug with wet
hands.
 Do not run over, crush or pull the
power supply cord or extension cord,
otherwise it may be damaged. Pro-
tect the cable from heat, oil and sharp
edges.
 The extension lead must have a cross
section in accordance with the oper-
ating instructions and be protected
against splashed water. The connec-
tion must not be in water.
 Always wear gardening gloves when
handling or working near the sharp
blades.

Electrical Safety

 Warning! Switch off, remove plug
from mains before adjusting,
cleaning or if cable is cut, damaged
or entangled.
 The tines/blades continue to rotate
for a few seconds after the ma-
chine is switched off.
 Caution – do not touch rotating
tines/blades.
Your machine is double insulated for
safety and requires no earth connec-
tion. The operating voltage is 230 V AC,
50 Hz (for non-EU countries 220 V,
240 V as applicable). Only use ap-
proved extension cables. Contact your
Bosch Service Centre for details.
Extension cords/leads should only be
used if they comply with H05VV-F,
English | 13
F 016 L81 256 | (11.3.15)