ESX vision Serie-VE1000.1 Bedienungsanleitung Seite 17

LOUDSPEAKER WIRING & CONNECTION
Monoblock Amplifier VE 1000.1 / VE 1800.1
1-Channel-Monoblock Amplifier / 2 Subwoofer
RADIO / HEAD UNIT
LINE INPUT
SLAVE MASTER
AMP AMP
IN/OUT
LCH RCH
LINE
OUTPUT
CONNECTION
• Connect the head unit line outputs (FRONT or REAR L & R) with amplifier's RCA LINE INPUTs with appropriate RCA cables.
• Connect the subwoofer 1 (+) and (-) with the SPEAKER OUTPUT left (+) and (–), subwoofer 2 (+) and (-) with the SPEAKER
OUTPUT right (+) and (ñ) of the amplifier.
• The final impedance should not be lower than 2 Ohms per Subwoofer. Please ensure correct polarity.
MASTER/SLAVE - SWITCH
• F2 should be set on MASTER AMP - position.
SUBSONIC - CONTROL
• Eliminates the lowest frequencies to protect the speakers from damages. These low frequencies can cause damages
to your Loudspeakers. The cut off frequency is adjustable from 10 Hz up to 50 Hz by using T1.
LOW PASS - CONTROL
• The built in low pass filter is fully variable from 40Hz to 350Hz by using T2. The cut-off frequency should be between
50 - 100Hz depending on the size of the speakers.
BASS BOOST - CONTROL
• Allows you to adjust the bass boost from 0dB up to +18dB by using T3.
Caution! Please use the BASS BOOST carefully. The additional boost may result in clipping or overload.
ACOUSTICAL PHASE SHIFT - CONTROL
• Controls the phase between 0 - 180 degrees by using T3.
INPUT GAIN - CONTROL
• Turn the INPUT GAIN - control (T4) on the amplifier to "9V" Position.
• Turn the head unit volume control to about 80-90% of its full setting.
• Turn the INPUT GAIN - control (T4) clockwise until you hear some distortion.
• Then turn back the INPUT GAIN - control (T4) slightly until you can hear clean sound.
Please ensure correct polarity for all connections like indivated on the devices.
Incorrect phasing of the speakers results in total loss of bass response.
MIN MAX
LEVEL
BASS REMOTE
MIN - MAX Level Controller
White LED = Operation Mode
Red LED = Protection Mode
(see page 19)
Caution!
Ensure not to connect speaker (-) to the ground or vehicle chassis.
17
SUBWOOFER SUBWOOFER
4 OHMS 4 OHMS
Protect
Bridge
BRIDGE