Subsonic Filter; Bass Boost - ESX vision Serie-VE1000.1 Bedienungsanleitung

FUNCTIONS & CONTROLS TOP PANEL
Monoblock Amplifier VE1000.1 / VE1800.1
T1

SUBSONIC FILTER

Controls the cut-off frequency downwards because
too low frequencies can cause damages
to your Subwoofer. It is variable between 10Hz - 50Hz.
T2
LOW PASS
Controls the cut-off frequency of the lowpass, that means
the frequency response is limited upwards.The cut-off frequency
is continously variable from 40 Hz up to 350 Hz.
T3

BASS BOOST

This switch allows you to adjust the bass boost from
0 up to 18 dB. Please use the Bass Boost carefully.
T4
INPUT GAIN
Adjusts the input sensitivity of the input signal from 0,15 up to 9 Volts.
T5
ACOUSTIC PHASE SHIFT LEFT
Controls the Phase between 0 - 180 degrees, this feature allows
to move the virtually soundstage position of the Subwoofer.
T6
DISPLAY
If the display is lighten up in white, the amp is in ready for use.
If the display is lighten up red, a malfunction is to be on hand
and the amplfier's PROTECTION MODE is active.
NOTE: If the amplifier's top-panel is white illuminated, the amplifier is in power mode. If the display is red illuminated,
the protection mode of the amplifier is activated caused by a malfunction (See page 19)
CAUSES: Overheating, short circuit on the speakers, overload (caused by low-impedance or low-power) or damage .
15
25Hz 25Hz
15Hz 15Hz 35Hz 35Hz
10Hz 10Hz 50Hz 50Hz
200Hz
150Hz 250Hz
40Hz 350Hz
T6
T1
T2
T3
T4
T5