ESX vision Serie-VE1000.1 Bedienungsanleitung Seite 14

FUNCTIONS & CONTROLS FRONT/REAR PANEL
Monoblock Amplifier VE1000.1 / VE1800.1
F1
IN/OUT-MASTER/SLAVE
Output of the Slave- or Input of Slave-Amplifier.
F2
MASTER/SLAVE SWITCH
This allows you to select between Master or Slave mode. See page 18.
F3
LINE INPUT
This allows you to connect the amplifier with the head unit via an RCA to RCA cable.
F4
LINE OUTPUT
Provides a full range line level (RCA) output that allows the use of additional amplifiers.
F5
BALANCED INPUT
Accepts balanced line inputs for the accordant line driver.
F6
REMOTE
Terminal for remote control to adjust the Bass Boost.
F1
IN/OUT
R1
R1
FUSE
Fuse block to prevent damages of the amplifier. Attend the notes on page 12!
R2
REM
Connection for remote turn-on of the head unit. Attend the notes on page 12!
R3
BATT +12V
Connection for the plus terminal of the vehicle`s battery. Attend the notes on page 12!
R4
GROUND
Connection for the ground (minus terminal). Attend the notes on page 12!
R4
PROTECT BRIDGE
Connection for Protect Cabel to connect the Master- and Slaveamp. See page 18!
R6
SPEAKER OUTPUT
Connection for the one or two subwoofers. Attend the several examples on the following pages!
F2 F3 F4
LINE INPUT
LCH RCH
SLAVE MASTER
AMP AMP
LCH RCH
LINE OUTPUT
R3
R2 R4
14
F5 F6
Protect
Bridge
BRIDGE
R5
R6