Explanation Of Symbols; Safety Advises - Wss Atelier F/R Montageanleitung

Safety Advises

Symbol Signal Word
cAUTIon
others
ATTEnTIon
ATTEnTIon
Instruction
(without signal word)
information for written version/documentation
Avoid injuries, damages and malfunction by
following all instructions.
a) ATELIER F/R – Panic Locks for all-glass doors of Wilh.
Schlechtendahl & Söhne GmbH & Co.KG (hereinafter
referred to as WSS) are designed for installation of single
leaf doors.
b) Before installation of the emergency exit- or panic
device onto a glass door, please check if this door is
suitable for the installation of the panic device. Before
installation of the emergency exit- or panic device
onto a fire resistant- or smoke control door, it must be
checked whether the emergency exit device is suitable
and approved for this particular door (see enclosure B,
DIN EN 1125 and DIN EN 179).
c) Only persons who are familiar are permitted to install
and maintain the panic locks. They must be tasked
with the installation and the maintenance by the con-
tractor.
d) They must know the relevant standards and regula-
tions (e.g. DIN EN 1125, DIN EN 179, etc. ..) and have
to be instructed accordingly. They must have read
and understood the assembly instruction provided by
WSS.
e) If more than one person is in charge of any of the
above works, the contractor must designate a person
who is authorised to supervise.
f) Only use immaculate components, locks, fittings, etc.
g) Check all parts for completeness and immaculate quality
before assembly.
14 GB

Explanation of Symbols

Meaning
potential dangerous
situation
potential dangerous
situation
useful tips for optimal
operation
1. Safety Advises
h) The door must be checked for correct resp. easy and
i)
j)
k) Glass doors or glass inserts, which are equipped with
l)
m) Emergency exit devices are not suitable for double
n) The lever handle or panic rod bar resp. panic push bar
Possible damages to non-compliance
slight injuries or damages
damages to device or its
environments
non
unobstructed opening and should not be warped.
When using door seals it must be ensured that these do
not affect the intended use of the door or the functions
of the panic device.
For panic devices according to DIN EN 1125 it has to
be ensured that the correct lengths was installed. The
maximum effective rod length should be selected – at
least 60% of the door leaf width must be available for
activation.
an emergency exit- or panic device, should be made of
safety glazing (safety glass or laminated safety glass).
For installation of an emergency exit door device to
different door types, different fixing pieces may be
required, which differ from those contained in the
package. A solid fixing piece which meets all require-
ments has to be selected by the installer or WSS has to
be consulted.
action doors.
should normally be installed at a height between 900
and 1,100 mm above the surface of the finished floor. If
the majority of the users are small children, a reduction
of the handle height should be taken in consideration.
Wilh. Schlechtendahl & Söhne GmbH & Co. KG