Changing The Protocol And Baud Rate - Abus TVAC26000 Bedienungsanleitung

5.2 Changing the protocol and baud rate

The example below describes how you can change the protocol in Pelco-D and the baud rate to 4800 for
Speeddome 002:
1. From the standby mode (Fig. 1), press and hold down the "Setup" button for three
seconds (Fig. 2).
2. Enter the password (Fig. 3, standard password: 8888).
3. Press "Enter" to go to the Setup menu. Navigate with the joystick to PTZ SETUP (Fig. 4).
4. Press "Enter" to go to the PTZ menu.
5. Move the joystick to the left or right to select the Speed Dome address (Fig. 5). Then
press "Enter" to confirm the changes (Fig. 6).
6. Move the joystick up and down to select the protocol (Fig. 7).
7. Move the joystick to the right to change the baud rate (Fig. 8). Then move the joystick to
select the baud rate (Fig.9).
8. Press "Enter" followed by "ESC" until you are in standby mode.
(Fig. 1).
9. The configuration is now complete.
DVR ：01
Fig. 1
PTZ SETUP
PW
SYS SETUP
Fig. 4
CAM :
PW
P : PELCOD
Fig. 7
DVR ：01
ENTER PW: ：
Fig. 2
CAM
P : PELCOP
Fig. 5
CAM
002
BR: 096 P : PELCOD
Fig. 8
DVR ：01
ENTER PW :
:
002
PW
BR: 096
P : PELCOP
: CAM
002
PW
BR: 096
P : PELCOD
22
English
****
Fig. 3
CAM :
002
PW
BR: 096
Fig. 6
:
001
PW
BR: 048
Fig. 9