9 Maintenance and cleaning
9 Maintenance and cleaning
9.1 Daily cleaning
9.2 Daily maintenance
EN - 12
Scheduled maintenance and cleaning is a prerequisite for a long life and a
trouble-free operation. In doing so, observe the following:
DANGER
Risk of injury due to unexpected start-up
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power source.
• Close off the compressed air supply.
• Pull the mains plug.
DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation.
• Replace any damaged, deformed or worn parts.
NOTICE
• The maintenance intervals given are standard values and refer to single-
shift operation.
• Maintenance and cleaning work may only be carried out by qualified
personnel (in Germany see TRBS 1203).
• Always wear your personal protective clothing when performing
maintenance and cleaning work.
1 Clean the gouging torch to remove weld spatter and impurities.
1 Check the gouging torch for damage and replace damaged parts if
necessary.
2 Ensure that all screwings are tight and retighten them, if necessary.
Gouging torch G3000/G4000