Technical Data - Abicor Binzel G3000 Originalbetriebsanleitung

2 Product description
2 Product description
2.1 Designated use
2.2 Use contrary to the designated use

2.3 Technical Data

Transport and storage
Relative humidity
Tab. 1 Ambient conditions
Electrode
Length of hollow cable
Type of use
Type of cooling
Tab. 2 General data
Type of voltage
Polarity of the electrode
Idle voltage or ignition voltage
Tab. 3 Electrical system
EN - 4
The gouging torches are air-cooled. All elements together form an operating
unit which provides a plasma arc for melting when supplied with the
appropriate operating resources and air-blasts the melt by means of
compressed air. Observe the prescribed operating, maintenance and servicing
instructions. In addition, the operator must ensure that the welding torch and
welding unit comply with the EC EMC Directive (2014/30/EU) and that the
signal utilization of the integrated welding current monitoring against stray
currents is installed properly.
Any use other than that described under "Designated Use" is considered
contrary to the designated use. Unauthorized conversions are not allowed. The
warranty does not cover wear parts and damage due to overloading or
improper use.
AC or DC
DC usually positive for cast steel and steel alloys
DC negative for non-ferrous metals, manganese hard steel,
grey cast iron
AC for grey cast iron, aluminium, nickel alloys
approx. 60 V
Gouging torch G3000/G4000
- 30 °C to + 55 °C
up to 90 % at 20 °C
Carbon electrode, round or flat
2.1 m and 3.0 m
manual
Compressed air