Set Up The Blades; Usage Of The Electric Plate Shear - Westfalia J1J-SH01-2,5 2625 Bedienungsanleitung

Set up the Blades

Adjust the space between the blades with the
fastening screw (D) with the aid of the enclosed
feeler gauge (1).
1. Adjust the fastening screw (D) with Allen key, so
that you could edge in the feeler gauge for the
required thickness between the blades. The
adjustable range is 0.1 to 0.45 mm.
2. If you want shear small radii, adjust a space of
0.3 mm between the blades.
3. For thicker materials adjust 0.3 mm.
4. For thinner materials adjust the space as follows:
Space = 0.2 x thickness of the iron sheet
This method refers to materials with a shear strength of 390 N/mm². The
value should be lower when cutting soft and tough materials. Enlarge the
value when cutting hard and fragile materials.
Shear strength:
Shear strength
Shear strength
Shear strength

Usage of the Electric Plate Shear

Take the unit always with both hands. Put one hand on the grooved gripping area
(G) and the other to the motor housing (H) for safety guidance. Never grasp the
tool on the cutting-head or the protection plate.
1. To switch ON push the ON/OFF switch (B) in direction of the
arrow until it locks. To switch OFF press the ON/OFF switch
lightly down und let it slide back to the starting situation. Let
the unit run until it has reached full speed. Apply the blade
tip on the fixed workpiece and let the blade work along the
cutting line. So it can work smoothly. Do not put large
pressure on the workpiece. Guide the tool only along the
cutting line.
2. Take care that the working piece is always below the protection plate.
Therewith you avoid too far folding and blocking the material, bad cuts and
injuries.
Operation
390 N/mm²
600 N/mm²
800 N/mm²
= 2.5 mm Thickness
= 2.0 mm Thickness
= 1.5 mm Thickness
6
D
1