Maintenance And Service; Troubleshooting; Disposal Information - WOLFF 68679 Originalbetriebsanleitung

Maintenance and Service

Maintenance and Cleaning
► Before any work on the machine itself, pull
the mains plug.
► For safe and proper working, always keep
the machine and ventilation slots clean.
After finishing work, dismount the clamping fixtures
and clean all clamping parts as well as the protective
cover.
When the carbon brushes are worn out, the machine
switches itself off.
The machine must then be sent to an after-sales
service agent. Addresses are listed in the Section
"After- sales service and customer assistance".
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service cen-
tre for WOLFF power tools.
In all correspondence and spare parts orders, plea-
se always include the 10-digit article number speci-
fied on the type plate of the machine.
10/2012 Estrichfugenschneider EF 135, #68679

Troubleshooting

Fault Possible cause
The machine does not start Power supply interrupted
Defective fuse
Defective cable
Defective plug
Higher exertion of force Cutting blade dull
required while working
Machine automatically Carbon brushes worn
switches off

Disposal information

Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools
into household waste!
According the European Guideline
2002/96/EC for Waste Electrical
and Electronic Equipment and its implementation into
national right, power tools that are no longer usable
must be collected separately and disposed
of in an environmentally correct manner.
Subject to change without notice.
Remedy
Contact
electrician
for repair and/or
replace parts
Replace
cutting blade
or resharpen
Contact
electrician
to replace
26