D) Digitalisation Of Cassettes - Renkforce TP-1010USB Bedienungsanleitung

• Push the STOP/EJECT (13) button to stop the recording.
• Push the button STOP/EJECT (13) again to remove the inserted cassette.
Recording is automatically stopped when the tape end has been reached.
Copying function
• Prepare the recording by performing the steps described in "Recording".
• Insert the cassette to be copied into drive A.
• Push the DUBBING (7) button to activate the copying function. The copying function takes place at regular belt
speed here. With the copying function activated, a green control LED lights up in the display (3) above the button.
• Additionally push the button HI.SPEED-DUBBING (8) to copy the cassette at double tape speed. With the HI-
SPEED-DUBBING function activated, a red control LED lights up in the display (3) above the button.
If possible, set the regular copy speed, since this will improve audio quality.
Do not change the copying speed during playback.
• Push the button PAUSE (14) at drive B.
• Push the RECORD (15) and PLAY (10) buttons of drive B at the same time.
• Push the button PLAY (10) of drive A and concurrently the button PAUSE (14) at drive B. Copying starts.
• During copying, a right indicator LED lights up in the display (3) at the upper right.
When copying from deck A, the recording is balanced automatically. The signal level for the recording can-
not be influenced with the REC LEVEL controller.
• Press the STOP/EJECT (13) button at both drives to stop the recording.
• Push the button STOP/EJECT (13) at both drives again to remove the inserted cassettes again.
Fast copying is automatically stopped when the tape end has been reached.

d) Digitalisation of Cassettes

There are many free or freely available software programmes available for digitising cassettes. Install a
corresponding program on your computer.
• Prepare the playback by performing the steps described in "Playing a Cassette" to the item Start playback.
• Push the PLAY (10) button to start playback.
• Start recording in the software you use. Please observe the corresponding help functions or the manual of the
software you use.
• The level setting for recording is usually done in the software. The GAIN controller on the rear of the cassette deck
can, however, be used to pre-adjust the level of the audio signal for the computer accordingly. If the audio signal at
the computer overmodulates, reduce the output level. If the audio signal at the computer undermodulates, increase
the output level with the GAIN controller (3).
28