Features; Set-Up; Connection - Renkforce TP-1010USB Bedienungsanleitung

6. Features

• Double cassette deck with full auto stop
• Copying cassettes with normal and double speed
• LED level indicator
• USB output for digitalisation of cassettes
• GAIN controller to adjust the audio signal at the computer
• CrO2 selection switch

7. Set-Up

When selecting the set-up location, please take into consideration the room layout such as the whereabouts of the
nearest socket, etc.
When selecting the set-up site, observe that direct sunlight, vibration, dust, heat, cold and moisture must be avoided.
There also must not be any strong transformers in the device's proximity.
Only operate the device on a stable, horizontal surface. There must be enough air circulation to
permit dissipation of the generated heat. Therefore, only place the device on a level surface and not
on carpets, etc. Do not cover up the ventilation slots in the casing.
Non-observance of this note may cause damage to the device.
Do not drill or screw any additional screws into the casing to mount the device. This damages the
device and it may become possible to touch potentially fatal mains voltage.
Make sure you position the device safely. Falling devices may pose a significant risk of accident.
Due to the diversity of furniture paints and polishes used, it is possible that the device's feet will
leave visible residue on furniture due to chemical reaction.
The device therefore should not be placed on valuable furniture surfaces without any suitable
protection.

8. Connection

Before connecting the device, ensure that the mains plug is disconnected. Also disconnect all
other devices to be connected from their power supply.
Observe connection of the audio connections in the correct direction, i.e. always connect left to left and
right to right.
22