Safety Instructions - Stiga Titan HYTT Montageanleitung

EN
1 GENERAL
This symbol indicates CAUTION.
Serious personal injury and/or damage
to property may result if the
instructions are not followed carefully.
You must read these instructions for use
and the machine's safety instructions
and instructions for use carefully.
1.1 SYMBOLS
The following symbols appear on the machine.
They are there to remind you of the care and atten-
tion required in use.
This is what the symbols mean:
Warning!
Read the instruction manual and the
safety manual before using the
machine.
1.2REFERENCES
The figures in these instructions for use are num-
bered 1, 2, 3, etc.
Components shown in the figures are marked A, B,
C, etc.
A reference to component E in figure 5 is written
"5:E".

2 SAFETY INSTRUCTIONS

• Please read through these instructions carefully.
Learn all the controls and the correct use of the
unit.
• Fit all cables according to the instructions.
Loose cables can cause wear and vibration
damages.
• Protect all cables from moving parts on the
machine. Friction can cause wear damages.
• Check regularly that the cable insulation is
intact and that the above mentioned is fulfilled.
• Cutting deck with high lifting beam is never
allowed to be used with the cabin. There is a
risk of interference between cabin and deck
with the deck in service position. On cutting
decks with end numbers -11 or -12, the lifting
beam must be replaced with with a low lifting
beam before the cutting deck is allowed to be
used.
• Check that the hammer always is in its place in
the cabin. The hammer is intended to crush the
glass in emergency.
8
ENGLISH
The accessory kit consists of one or both of the
following items:
• Cabin with heating.
• Electrical equipment for driving on public
roads.
Note! This instuction is delivered with and
describes both of the alternatives above.
Therefore, use only applicable parts of the
instruktion.
Before carrying out the assembly work,
the power must be cut using the main
switch. Risk for short circuit and fire.
4.1 MAIN SWITCH
Cut the power using the main switch. See fig. 1.
4.2 REAR LIGHTS WITH RAMP AND
CABLE HOLE
1. Remove the upper engine casing and drill a hole
according to the drawing in fig. 2.
2. Refit the casing and assemble the ramp (3:E) in
the rear screws.
3. Assemble the following in the ramp:
• Upper edging (4:X).
• The sign (5:S) if necessary.
4.3 CONTROL
Assemble the control front right as described
below:
1. Remove the black cover washer in the steering
pulpet.
2. The bracket (6:I) and the control (6:H) are
delivered assembled. Separate these.
3. Assemble the bracket (6:I) for the control (6:H).
Use two screws, threaded direct into the
steering pulpet.
4. Insert the cable into the pulpet and fit the cable
grommet into the hole.
5. Draw up the rubber protecting at the control and
fasten with 4 screws and 4 nuts.
4.4 INDICATORS
Asseble the following:
• Monitor lamp for indicators.
• Switch for hazard flasher.
1. Make one square and one circulare hole,
according to fig. 7.
2. Assemble the monitor lamp and the switch in
the holes.
3 DESCRIPTION
4 ASSEMBLY