Switching Off The Machine; Appliance Activation - Elektro Maschinen HDEm 2400Top Line Bedienungsanleitung

EN
4
HIGH PRESSURE PIPE CONNECTION
Modell HDEm 2400
- Insert the high pressure pipe (
appliance attachment ( )
- Rotate the plastic ring nut, thoroughly tightening it
- Turn on the water tap.
Modell HDEm 2410, HDEm 2710
- Unwind the pressure hose off the hose drum.
- Check connector for high pressure pipes (Fig. 6)
Assembly of the detergent spraying devic
(Fig. 7)
- Insert the nozzle into the spray gun
- Rotate the nozzle by 90°, and on extracting it
click it in.
5
ELECTRICAL CONNECTION OF THE
APPLIANCE
The mains voltage must match the operating voltage.
(See identification plate)
- Insert the plug into a power socket installed in
compliance with regulations.
Check the minimum section of the individual cables
using extensions.
Position the extensions so as to maintain the protection
class of the equipment.
Voltage Cable
V length m
230 up to 2
230 20 to 5
6

APPLIANCE ACTIVATION

Operate the equipment in vertical position
only after connecting the water supply pipe
and turning on the tap (fig.2)
- Press button I (Fig.8-ON) on the main switch posi-
tioned at the rear of the device
- Position the spray gun on the object to be
cleaned - never on people !
- Press the safety device (Fig. 9 - pos. 1) - the gun is
released
- Direct the nozzle downwards (Fig.2)
- Fully press down the trigger (Fig. 9 - pos.2)
- Press the button marked with an 0 on the switch
)
- Turn off water supply tap.
- Actuate spray gun until water drips from the nozzle
- Release trigger.
- Press safety latch on spray gun. (Fig.10). The spray
- Unplug machine from socket outlet.
- Disconnect water supply hose from machine and
Variable nozzle
The nozzle (6 - Fig.1) can be adjusted continuously by
turning the black bushing: from a pinhole jet (Fig.11)
to flat jet (Fig.12). Furthermore, you can also change
the pressure from low pressure to high pressure by
The turbo nozzle, is ideal for maximizing cleaning,
cannot be adjusted.
Cross-section
2
mm
1,5
2,5
ADDITION OF DETERGENT
The detergent selector
the suction detergent tanks
increase /decrease detergent flow.
Fill the detergent tank (   Fig. 1 ) with detergent,
7

SWITCHING OFF THE MACHINE

(Fig. 8 - OFF)
(machine is now de-pressurized).
gun is locked and cannot be actuated accidental-
ly.
water supply mains.
8
ACCESSORIES
(Fig. 13-14).
(5 - Fig.1)
(1  Fig.1) +'(P  +'(P 
HDEm 2410 and HDEm 2710
hose
The detergents must not be al-
lowed to dry on the object to be
cleaned.
This product is equipped with detergent tanks.
( 3 - Fig. 1 )
as recommended. (see paragraph "General
recommendations" in this booklet).
regulate
( 1 - Fig. 1 ) and