AEG Electrolux SKZ81200F0 Benutzerinformation Seite 16

16
What to do if...
Problem
The appliance is noisy
The appliance does not
operate. The lamp does
not operate.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the COOLMATIC
switch, or after changing
the temperature.
Water flows on the rear
plate of the refrigerator.
The temperature in the
appliance is too low/high.
The temperature in the re-
frigerator is too high.
Possible cause
The appliance is not supported
properly
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set cor-
rectly.
The door is not closed correctly.
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
This is normal, no error has oc-
curred.
During the automatic defrosting
process, frost defrosts on the
rear plate.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Solution
Check if the appliance stands sta-
ble (all the four feet should be on
the floor)
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap-
pliance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
The compressor starts after a pe-
riod of time.
This is correct.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.