AEG Electrolux SKS68808F0 Benutzerinformation Seite 30

30
What to do if...
Problem
The sound level in the
cabinet is too high
Water flows at the back
plate of the refrigerator
Water flows into the re-
frigerator compartment
Water flows onto the
floor
The lamp does not work.
It is too warm in the re-
frigerator
It is too cold in the refrig-
erator
The appliance does not
work at all. The appliance
does not cool at all. Nei-
ther cooling nor lighting
works
Possible cause
The door has been opened too
frequently
Food placed in the appliance was
too warm
The temperature of the room
that contains the appliance is
too high for efficient operation
The pipes, at the back of the
cabinet, touch each other
During automatic defrosting,
frost melts on the back plate
The outlet can be clogged up
Products placed in can prevent
water from flowing into the col-
lector
The melting water outlet flows
not into the evaporative tray
above the compressor
The lamp is in stand-by.
The lamp is defective.
The Temperature regulator may
be set incorrectly
The door does not close tightly
or it is not shut properly
Food placed in the appliance was
too warm
Large quantities of food to be
cooled were put in at the same
time
There is no inside cool air circu-
lation
The Temperature regulator may
be set incorrectly
The appliance may be switched
off
Plug is not connected to the
mains socket properly
Solution
Do not leave the door open longer
than necessary
Allow food to cool to room tem-
perature before storing
Try to reduce the temperature in
the room where the appliance
stands
Carefully bend them
It is normal
Clean the outlet
Replace the products so that they
can not touch the back plate di-
rectly
Put the melting water outlet to
the evaporative tray
Close and open the door.
Refer to "Replacing the lamp".
Set a lower temperature
Check if the door closes well and
the gasket is undamaged and
clean
Allow food to cool to room tem-
perature before storing
Insert smaller quantities of food
to be cooled at any one time
Provide inside cool air circulation
Set a higher temperature
Switch on the appliance
Connect the mains plug properly