Description Of The Appliance; Safety Instructions; Before Using For The First Time - Electrolux ZB 260 Gebrauchsanweisung

ZB260.book Seite 8 Donnerstag, 10. August 2000 10:41 10
g
g Dear Customer,
Please read these operating instruc-
tions carefully. Above all please
observe the safety information on the
first pages of these operating instruc-
tions! Please keep these operating
instructions for later reference. Pass
them on to any subsequent owner of
the appliance.

Description of the appliance

1 Dust container
2 Liquid collector
3 Dust filter
4 Release button
5 Charge control display
6 On/off switch
7 Charge socket
8 Wall mounting and charger
9 Jack plug
10 Mains plug
11 Wet vacuuming nozzle
12 Fold-down crevice nozzle
1

Safety instructions

• Do not vacuum wet surfaces.
• Do not use the vacuum cleaner on sur-
faces that have been treated with
flammable solvents until they are com-
pletely dry.
• Do not use your vacuum cleaner to
vacuum hot items such as a glowing
cigarette end.
• Never use the vacuum cleaner to pick
up combustible dust.
• Under no circumstances should you oil
or grease the motor.
• Do not expose the vacuum cleaner to
direct sunlight or any source of heat.
• For maintenance and repair please
contact your local dealer or authorised
service personnel. Never attempt to
repair your vacuum cleaner yourself.
• Only use the appropriate original
charging devices for this model.
8
This appliance complies with the fol-
;
lowing EC directives:
– 73/23/EWG dated 19.02.1973 "Low
Voltage Directive", including Direc-
tive Amendment 93/68/EWG
– 89/336/EWG dated 03.05.1989 "EMC
Directive", including Amendment
Directive 92/31/EWG

Before using for the first time

Before you use your vacuum cleaner
for the first time you should charge
the battery for approx. 14-16 hours.
With a fully charged battery you can
vacuum with model ZB 260 for approx.
9 minutes and with model ZB 264 for
approx. 10 minutes.
Attaching the wall mounting
(Fig. A)
To attach the wall mounting select a
position near a room socket and
remote from any source of dampness.
0 Hold the mounting against the wall
and mark the points for the fastening
screws.
0 Use a drill to drill the holes for the
screws, push in the plastic plugs pro-
vided and insert the screws so that
they project by just 7 mm.
0 Position the wall mounting, lower it
over the two screws and then tighten
the screws securely.
The appliance can equally well be
3
stored standing on a table, the floor or
any other horizontal surface.
The wet vacuuming nozzle can be
3
stored in the wall mounting (Fig. B).