Küppersbusch IKEF2580-0 Benutzerinformation Seite 14

14
Problem
A rectangular symbol is
shown instead of numbers
on the Temperature Display.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after press-
ing the FastFreeze, or after
changing the temperature.
Possible cause
The temperature in the ap-
pliance is too high.
Temperature sensor prob-
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FastFreeze is switched
on.
The Shopping is switched
on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor-
rectly.
This is normal, no error has
occurred.
Solution
Contact a qualified electrician
or contact the nearest Author-
ised Service Centre.
Contact the nearest Authorised
Service Centre (the cooling sys-
tem will continue to keep food
products cold, but temperature
adjustment will not be possi-
ble).
Close and open the door.
Contact the nearest Authorised
Service Centre.
Refer to "Operation".
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "FastFreeze function".
Refer to "Shopping function".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products better.
Refer to "Operation" .
The compressor starts after a
period of time.