Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting central locking rod to original rod
- retract the lifting part of servmotor, position the original rod to „unlock"
- Fast the rod to the original rod by means of a clamp.
Attention! Accurate setting!
- When the door is locked or unlocked with the door key, the servmotor should
actuate the central locking system at half coure of the key.
- Repeat the setting of the connection rod if necessary.
remote control functions
Press the Lock button:
- The doors locked
- Turning light lights for 2 full seconds.
- Indoor light turns off after 5 seconds of delay.
- A very short signal (0.3 seconds) will sound.
Press the unlock button:
- The doors unlocked
- Turning light flashed two times.
- Indoor light turns on after 5 seconds of delay.
- If you dont open any door within 60 seconds, the controll unit will lock again.
Press the unlock button for more than 2 Seconds:
- The red / black wire gives +12 V / 500 mA out (relay output). Until you press
the Lock-/Unlock-button again longer than 2 seconds.
Press the Carfinder/Signal button:
- The indicator will flash for 25 seconds (1 time per second).
Press Carfinder/Signal button longer than 2 seconds:
- Disables the locking signal.
Info: The horn is connected to the pink wire (9). If the signal is too loud, use a Buzer
(optional, not included) to reduce the volume.
17
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
