SinusTEC ZV II Betriebsanleitung Seite 13

Please observe the following instructions:
When working on the lines:
!
30 - (input from positive battery plus direct),
15 - (switched plus, behind battery)
31 - (return cable from battery, ground)
L - (left turn signal lamps)
R - (lamps right turn signal)
The safest type of connection is to solder the cable ends and then isolated. For relea-
sable connections only isolated Terminals, connectors and receptacles used. No crimp
(Cable connector) or terminal blocks use.
To connect the cable with connectors, plugs or receptacles using a crimping tool. For
cable connections to 31 (mass):
The cable lug and pulley to a vehicle's mass screws or bolts with ferrule, plate bolt and
lock washer on the Body sheet metal screws. Keep a good mass transfer!
Warning!Because of the risk of short circuits, always disconect the
!
negativ pole of the battery before starting work. At vehicles with a
second battery, you must also disconnect this negativ pole.
!
Attention! When disconnecting the negative terminal of the
battery will lose all memory of the volatile electronics comfort
their stored data.
The following data must ever re-enter the vehicle equipment:
- Radio Code
- vehicle clock
- Timer
- on board computer
- Seat position
Instructions for setting you can read in its own manual.
Warning! In the vehicle-mounted parts of the ST-ZVII must be secured
fixed so that they can be solved under any circumstances (sharp decelerati-
!
on, traffic accident) and cause injury to vehicle occupants can.
13