Tools Required; Sign-Up Radio Remote Control; Installation Of The Control Unit - SinusTEC ZV II Betriebsanleitung

Tools Required

Soldering iron
For installation and assembly
are required:
Solder
- scale
grains
- grains
crimping tool
- hammer
- drill
hot blow drier
- drill bits
- screwdriver
hammer
For the electrical connection
and verification is needed:
- diode test lamp or voltmeter
scale
- crimping tool
Driver Set
- insulating tape
- shrinkable tubing
- hot blow drier
- soldering iron
drill
- solder
bits Set
For mounting the receiver and
Cable, you may also need screws,
voltmeter
Sheet metal screws and cable ties.
diode test lamp
Sign-up radio remote contro
l
To intigrate additional Sinustec wireless remote controls in the unit, press and hold
the learning swich button and press the lerning remaote control. The included wireless
remote control is already trained

Installation of the control unit

mechanical Installation
Start with the installation of the driver's door. Remove the crank handle of the window
winder and the arm rest and remove the inside panelling of the door.
15