Operation; Remote Control - Rusta 9065-1097 Gebrauchsanweisung

OPERATION

CAUTION! Once the appliance has been plugged in to a grounded electrical outlet, it is
ready to ope-rate. Ensure the house circuit breakers for the power supply are turned on.
In the event of a power failure, both the flame and heating function will remain turned off
when the power is restored.
The switch is located on the top right hand side of the appliance.
1. Main Switch
The main switch supplies power to all fireplace functions. Press the button to "I" side
to turn on the appliance, press "O" to turn off the appliance. When the main switch at "I"
side, press once to open the flame and heating function is ready to start.
2. Heating Function
It has two heat settings, first ensure the flame
is on by pressing , then press
900W. Press this button again, heating function
is turned off. Press
this button again, heating function is turned off.
NOTE! The fireplace can be turned off at any
point by pressing the button

REMOTE CONTROL

NOTE! Make certain the batteries are installed correctly and are new.
1. Make certain the appliance's main power switch "O/I" is at the "I" side. The remote
control will NOT work if the Main Power Switch is at the "O" position.
2. When operating the remote control, it must be directed towards the front center of the
appliance.
3. Press to open the flame and heating function is ready to start.
4. Press button on remote to make the flame function work. Press
this button once, the brightnessof flame is decreased or increased
gradually, and form a cycle. Press this button again, brightnessof
flame is fixed.
5. Press button, the heating function works and this is low heat
900W. Press , the power reach high heat 1800W.
6. Press the button
NOTE! This remote control must remain within 8–10 meters of the
appliance to be effective.
the power is
the power is 1800W. Press
.
again, all functions will be shut off.
7