Wall Mounting Instructions - Rusta 9065-1097 Gebrauchsanweisung

ENG

WALL MOUNTING INSTRUCTIONS

WARNING! Failure to install fireplace as instructed below may result in damage to
the equipment and or may expose the user to the risk of fire, serious injury, illness
or death.
CAUTION! Select an appropriate location to mount the unit on a wall, near an electrical
outlet. Access to the electrical outlet must be maintained. Ensure the installation meets
the national and state/provincial electrical codes.
1. Have two people hold the appliance against the wall to determine the final location
to maintain an optimized viewing angle of the flame. To ensure a suitable location for
mounting bracket, then make the holes.
2. First install the wall anchors into the holes, then tighten the mounting bracket by
screws supplied. (See the assembly description down below).
3. With the screws installed have two people lift the appliance up and insert the screws
into the keyholes on the back of the appliance.
4. Make sure the electric fireplace is firmly fixed.
5. Install anchors into the fixed block holes, secure using the screw provided.
6. Check the appliance for stability ensuring that the appliance will not pull free from the wall.
GLASS FRONT INSTALLATION
It is recommended that two people install this glass front onto the
appliance, wear safety glassesand gloves when handling glass.
1. Line up the brackets on the back of the glass with the
screws on the side of the appliance body.
2. Hang the glass front.
NOTE! For safety reason, please ensure the vent on heater is
not less than 150 cm away.
6
Screw
Wall bracket
Wall anchor
Shoulder
screw