Remote control
ENGLISH
06
Batteries
Install the batteries and make sure the positive (+) and negative (-) polarities
match as shown in Figure A.
Service life of batteries
• The batteries normally last for about one year despite that it depends on
how often and in what way the remote control is operated.
• Replace the batteries if the remote control fails to work even when it is ope-
rated near the DVB-S receiver.
• Use 2 pieces of 7 (AAA/UM-4) batteries.
Note:
• Do not use rechargeable (Ni-Cd) batteries.
• Do not attempt to recharge, short circuit, disassemble, heat the batteries or dispose of in fire.
• Do not drop or step on the remote control unit or subject it to shocks. Otherwise the parts of the remote
control unit may get damaged and lead malfunction.
• Do not use the new and old batteries together.
• Please remove the batteries if the remote control is not going to be used for a long period of time. Otherwi-
se, it may cause electrolyte leakage and lead malfunction, even fire accidents. Carefully wipe the electrolyte
out of the remote control compartment and replace with new batteries. If any electrolyte happens to touch
your skin, wash it off thoroughly with clean water immediately.
Remote control range
• Point the remote control to the IR receiver window. The remote control shall be effective within a distance of
about 5 meters and an angle of about 60 degrees as shown in Figure B.
• The effective range may vary slightly with the brightness of the room.
Note:
• Do not shine bright light to the remote control sensor.
• The remote control unit may not work if there are obstacles bet-
ween the remote control and the sensor.
• Do not recommend this remote control using for other products.
ENGLISH
07