Farmcomp Wile 25 Bedienungsanleitung Seite 5

And after that the probe selection display
Now you can change the display to correspond the
attached probe, merely depress F button repeatedly
until you have correct number.
For probes 1 and 2 the next display shows the density
setting of the bale (80-250 kg/m3), for example.
If the indicated number does nor correspond to the
desired reading, merely depress the F button until the
desired density figure appears. When internal
calculation in running the display shows
If you have made adjustment to the reading of the
selected scale, the meter will display the amount of
correction shortly, for example
The next number that appears will be the moisture
content of the bale, given the probe that you are using
and the bale density that you can chosen.
Check the calibration of the the meter regularly
according item 11.4.
4. ATTACHING OR CHANGING A PROBE
When you attach the probe to the Wile-25, first insert
the connector pin of the probe into the hole at the top
of the W-25, then firmly tighten the locking nut to the
unit. When attaching a probe, avoid bending the
connector pin.
The W-253 dish type probe is secured to the moisture
meter by turning the whole probe. There is no locking
nut for this unit.
You may now electronically set the W-25 for the model
of probe installed. Merely depress once the P (Power)
button and a number will appear in the display. Push
the F (Function) button repeatedly until the number, -1,
-2 or -3 , corresponds the attached probe. Your
selection will remain in memory until you require a
different probe type.
5. ADJUSTMENT OF THE READING
You can adjust each scale up or down in increments of
1/10 percent. When the moisture content is displayed,
first choose the direction of the adjustment up