Programming - IFM Electronic PB5 Bedienungsanleitung

5. Programming

Increase the switch-on point / switch-off point
Press the SET S-button*
and keep it pressed until the
requested switch point is
1
As soon as the LED starts
moving the switch point can
be increased (incremental by
pressing briefly or scrolling by
holding pressed).
2
Press the ENTER S-button*
briefly (acknowledgement).
* SET R button to set the switch-off point
ENTER R button to acknowledge the setting of the switch-off point
The switch-on point (S) is always higher than the switch-off point (R). The unit
does not accept values for R which are higher than S.
**Overflow: If the flashing LED and the lit LED exceed the maximum setting
value, the cycle starts again at the minimum setting value.
Decrease the switch-on point / switch-off point
Let the flashing and lit LEDs move to the maximum setting value. Then
the cycle starts again at the minimum setting value.
Locking / Unlocking
The unit can be electronically locked to prevent unwanted adjustment
of the set parameters: Press both pushbuttons for 10 s. Indication goes
out briefly (acknowledgement of locking / unlocking). Units are deli-
vered from the factory in the unlocked state.
16
SET S SET R
ENTER R ENTER S
[bar]
displayed.
SET S SET R
ENTER R ENTER S
[bar]
After 5s the flashing LED moves
from left to right.
fter LED 9 has been reached the
cycle starts again at LED 0. The
LED which is constantly lit moves
on by one position.**
The set switch point becomes
effective; the unit passes into the
operating mode.