Receiver; Beltpack Transmitter; System Setup; Receiver Setup - ANT UNO G8 Bedienungsanleitung

Series
2.3 | BELTPACK TRANSMITTER - UNO G8B
1 2 3 6 8 4 9
5
7
4 ASC/LOW BATT
Green LED steadily lit: transmitter on.
Green LED flashing: channel synchronization, ASC in progress.
Red LED steadily lit: MUTE function activated.
Red LED flashing: low battery.
5 IR WINDOW
It allows the synchronization of the channel (frequency) with the receiver.
After pressing the receiver ASC button, place the bottom of the beltpack transmitter
close to the IR window of UNO G8R receiver and wait for the selected channel to stop
flashing on the handheld display. After few moments the synchronization process
ends, and the RF signal level indicator will show the presence of signal.
6 SELECT
Press this button to select functions, and to set receiver parameters values.
7 BATTERIES COMPARTMENT
To replace the batteries, lightly press on the sides of the cover and lift forward.
Take out the old batteries, and insert two new batteries (respecting the compartment
icons) then close the lid. Remove the batteries from the receiver when not in use for
extended periods.
UNO G8 Series
8 User manual |
1
1 ANTENNA
It allows the transmission of the
signal.
2 MULTI-FUNCTION DISPLAY
This LCD features a number of
controls and indicators, such as the
group and channel number, icons of
MUTE and lock, and the 4-segment
battery status indicator.
NOTE: the backlight automatically
turns off after a short while.
3 ON/OFF - MUTE
Press this button for 2" to turn on or
off the beltpack transmitter.
Press it briefly to turn ON/OFF the
MUTE function.
8 MINI XLR-M INPUT
Connect to this input the provided HS-03 headset or the signal from
other sound sources.
9 GAIN SELECTOR
There are three different gain settings:
Mic: for supplied headset microphone and other microphones
0 dB: low output level instruments
-10dB: high output level instruments
WEARING THE BELTPACK

RECEIVER:

Clip the receiver to a belt or to
the shoulder strap of your guitar.
For better fastening reliability it's
preferable to secure it as shown
in the figure, then fasten it in a
way that the belt is tight from
the clip.

3 | SYSTEM SETUP

To achieve the best reception, please place the receiver at least 1 m
high and put the antennas vertically upwards. Avoid placing the receiver
close to metal objects or digital control devices (CD players, computers,
console, and so on). The receiver and transmitter must have a direct
"visual contact".

3.1 | RECEIVER SETUP

LCD main window shows indicators of audio (AF) and radio-reception
(RF) levels, followed by the indicators of Squelch (SQL), VOLUME, GROUP,
CHANNEL, ANTENNA DIVERSITY, SYNC and the lock icon, when it's active
To proceed with the adjustments, please use SET and up/down buttons.
GROUP SELECTION
• Press the SET button until when "GROUP" appears in the display. Use the
up and down buttons to select the desired group of frequency, then press
again SET to scroll following parameters and to confirm the choice.
UNO G8 Series
9
| User manual