Transmitter Setup; Tips To Better Use The System - ANT UNO G8 Bedienungsanleitung

Series
CHANNEL SELECTION - MANUAL SETUP
• Press the SET button until when "CHANNEL" starts flashing in LCD.
Use the up / down buttons to select the desired channel then press again SET
to scroll following parameters and confirm the choice. Simultaneously using
multiple systems, it is preferable to have them on the same frequency band but
on different channels.
CHANNEL SELECTION - ASC
• Press the SET button until when "CHANNEL - AUTO" starts flashing in LCD.
Use the up/down buttons to start the automatic channel scan, after searching the
receiver will set automatically the channel without interference. If the automatic
scanning is not successful, please repeat it until you find a free frequency.
SQUELCH SETTING
• Press the SET button until when "SQL" starts flashing in LCD.
Use the up/down buttons to select three different noise suppression settings.
L: lower value
M: intermediate value
H: high value
Starting a new session, always set the receiver on lower squelch value and gradually
raise the value in case of interferences. In critical conditions of the radio-reception,
H setting may reduce the signal transmission distance to the receivers.
VOLUME SETTING
• Use the up/down buttons to select volume level from 0 to 63.
ATTENTION: during the first powering, set the level to the minimum to allow various
settings, in particular that of SQL function.
LOCK ON/OFF
• The lock function is automatically activated after about 20" of device idle.
Press the SET key for 2" to turn off the lock and activate again the receiver.
ATTENTION: when the LOCK icon is shown , you can still see the unit settings,
but these settings are not editable.
UNO G8 Series
10 User manual |
3.2 | BELTPACK TRANSMITTER SETUP
LCD main window shows GROUP, CHANNEL and MUTE settings as well
as battery status. To proceed with the adjustments, please use SELECT
and MUTE buttons.
To proceed with the adjustments, please use SET and up/down buttons.
GROUP SELECTION
• Press the SELECT button until when "GROUP" starts flashing in LCD.
Use the same button to select the desired group of frequency, then wait
for steadily lit icon to confirm the choice.
CHANNEL SELECTION - MANUAL SETUP
• Press for 2" the SELECT button until when "CHANNEL" starts flashing
in LCD. Use the same button to select the desired channel, then wait
for steadily lit icon to confirm the choice. Simultaneously using multiple
systems, it is preferable to have them on the same frequency band but
on different channels.
MUTE
• Press the MUTE button to activate or deactivate this function.
MUTE ON setting allow to mute signal transmission toward the
receiver. When MUTE is activated, its icon is shown in the lower left
corner and the bi-color ASC/LOW BATT LED switches to red.
3.3 | TIPS FOR BETTER USE OF THE SYSTEM
To achieve the best reception, please place the receiver at least 1 m high
with the antennas pointing upward, in V shape. Please, make sure the
receiver and transmitter must have a direct "visual contact", i.e. with no
halfway obstacles and allowing a minimum 50 cm distance between
receiver antennas and any metallic object.
Don't place the receivers too close to digital control devices.
UNO G8 Series
11
| User manual