Closing The Door; Technical Data; Installation - Küppersbusch ITE1390-1 Benutzerinformation

Problem
The temperature in the
freezer is too high.
Upper or lower square is
shown in the tempera-
ture display.
dEMo appears on the
Display.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

Technical data

Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.
Installation
Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Possible cause
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
Products are too near to each
other.
An error has occurred in meas-
uring the temperature
The appliance is in demonstra-
tion mode (dEMo).
Height
Width
Depth
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Store products so that there is
cold air circulation.
Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible).
Keep pressed approximately
10sec the OK button since a long
sound of buzzer is heard and the
Display shut off for a short while:
appliance start works regularly.
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
1225 mm
560 mm
550 mm
24 h
230-240 V
50 Hz
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of
the appliance:
19
Solution