Defrosting Of The Freezer; Periods Of Non-Operation; What To Do If - Küppersbusch ITE1370-2 Benutzerinformation

22

Defrosting of the freezer

The freezer compartment of this model, on
the other hand, is a "no frost" type. This
means that there is no buildup of frost
when it is in operation, neither on the inter-
nal walls nor on the foods.
The absence of frost is due to the continu-
ous circulation of cold air inside the com-
partment, driven by an automatically con-
trolled fan.

Periods of non-operation

When the appliance is not in use for long
periods, take the following precautions:

WHAT TO DO IF...

Warning! Before troubleshooting,
disconnect the mains plug from the
mains socket.
Only a qualified electrician or compe-
tent person must do the troubleshoot-
ing that is not in this manual.
Problem
The appliance does not
operate.
The buzzer sounds. The
Alarm light flashing.
The compressor oper-
ates continually.
The temperature in the
freezer is too low.
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The temperature in the freezer is
too high.
The door is not closed correctly.
The temperature is not set cor-
rectly.
The door is not closed correctly.
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
The Fast Freeze function is
switched on.
The temperature regulator is not
set correctly.
The Fast Freeze function is
switched on.
• disconnect the appliance from elec-
tricity supply
• remove all food
• defrost (if foreseen) and clean the appli-
ance and all accessories
• leave the door/doors ajar to prevent un-
pleasant smells.
If the cabinet will be kept on, ask some-
body to check it once in a while to prevent
the food inside from spoiling in case of a
power failure.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap-
pliance to the mains socket.
Contact a qualified electrician.
Refer to "Excessive Temperature
Alarm".
Refer to "Door open alarm".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
Refer to "Fast Freeze function".
Set a higher temperature.
Refer to "Fast Freeze function".
Solution